User Manual

UTD1000L
User Manual
20
set DC autoset to off. If AUTOSET is applied, the
coupling mode is switched to AC mode.
2. Input 1kHz 2Vpp sine signal into two
channels then set AC coupling for one channel
and DC mode to the other When AUTOSET is
applied the coupling modes for both channels
keep unchanged
UTD1000L can offer creative auto function to
capture input signal With this function applied,
the Oscilloscope varies ranges accordingly based
on the input signal until the proper waveform
display can be obtained without any manual
interference.
To perform autoset function, do the following
1. Press SHIFT button, the shift
icon shows on
upper right corner of the screen
2. Press AUTO button when A icon displays on
the screen, autoset function has already turned on
When the model is UTD1000DL and both of
its two channels have signals, the signal from the
trigger source channel will be automatically
displayed and the other channel will turn off
under autoset mode if there is only one
channel input with signals this channel signal
will be automatically selected and displayed no
matter which channel has been choosen as the
trigger source.
,
,
.
,
.
.
:
,
;
;
,
Full Autoset for Input Signal
Note:
Figure 4-9 Full Autoset