User Manual

UTD1000L

User Manual

then connect the probe connector to the

oscilloscope input channel and the probe tip to

compensation output terminal

2. Then execute AUTO

3. Observe the displayed waveform

If the displayed waveform is under-or over-

compensated as indicated above, use the adjusting

tool with non-metal handle to adjust the variable

capacitor on the probe until correctly compensated

waveform shows

To avoid any electric shock when

measuring the high voltage with use of the probe,

please ensure the probe wire is perfectly insulated,

and do not touch any metal part of the probe while

connecting to the high volt

age source.

Press V mV buttons to adjust the vertical

scale(VOLT/DIV) and display waveform with proper

size on the screen

When channel cursor turns solid press Up

and Down button to adjust ground reference

point that can allow the waveform to display at

proper location

;

～

;

Warning:

Vertical System

Setting Vertical&Horizontal Systems

and Trigger Level Manually

Over compensation

correct compensation

under compensation