User Manual

UTD1000L

User Manual

and ensures the accuracy for measurements To

set up the probe factor on the Osciloscope

press CHANNEL button then F3 to set probe

factor to10

3. Conenct the probe to the output terminal for

probe compensation on the Oscilloscope, press

AUTObutton, after several seconds, squarewave

displays 1kHz 3Vpp Peak to Peak Value

See Figure 4-5.

You need to compensate the probe whenever

connecting it to channels for the first time so as

to match the probe to the input channel

Uncompensated probe may cause deviation or

error to the measurement. To compensate the

probe, do the following

1. First of all, set p

robe factor on the Oscilloscope

to 10 turn the switch to 10 on the probe

×.

( , , - - ),

×, × ,

Compensating the Probe

Figure 4 Adjusting Probe Factor

-4

Figure Squarewave Signal from the Oscilloscope Itself

4-5