User Manual

Resetting the Oscilloscope
To reset the Oscilloscope to the default, do the
following
1 Press SHIFT button, shift icon displays on
the upper right corner of the screen
2 Press UTILITY button and four options shows
on the bottom display
3 Press F2 button to select the default setup. Then
the Oscilloscope is set to the default settings
The Default setup is as follows:
The procedures below show you how to select
functions with use of oscilloscope menus
1. Press any functional button on the keypad, then
corresponding options will show on the bottom
display, you can select one of these options with
use of F1 F4 After that, press OK
button to
hide functional menus
:
. “ ”
;
.
;
.
;
;
~ .
;
Note: Pressing up arrow button can also set the
Oscilloscope to the default when powering on.
Using Functional Menus
UTD1000L
User Manual
14
Figure 4-2 Default Setup
Functions
SEC/DIV
Acquire Mode
VOLT/DIV
Trigger Coupling
Channel Status
Trigger Mode
Display Format
Persist Time
Display Style
Manual Display
Default Setup
Norma
1ms/div
100mV/div
DC
CH2 Off (1000DL series
)
Auto
Vector
Auto
Classic
Manual