User Manual

Chapter 4 Using Basic
Oscilloscope Functions
About the Chapter
Powering on the Oscilloscope
This chapter only briefs users on basic functions of
the Oscilloscope for example how to use
menus and execute basic operations not a
step by step introduction on all functions
UTD1000L Series can be powered by the
battery and power adaptor. The power supply
voltage from the adaptor is DC9V/1.5A To
operate the Oscilloscope normally please use
the power adaptor specified for the Oscilloscope
Press Power button and SHIFT light illuminates
for 3 seconds, then the Oscilloscope logo appears,
indicating the Oscilloscope has already turned
on.
Figure 4-1 Display Interface
Besides the waveform
, there are still a lot of details
about the waveform and oscilloscope control
settings on the screen:
1 Trigger source status:
CH1 CH2: indicates you can adjust the
waveform of this channel
, ,
,
- - .
:
.
,
.
.
/
Describing the Display
UTD1000L
User Manual
1
2