User Manual

UTD1000L
User Manual
11
: To toggle between vertical position and
trigger level if vertical position is
choosen vertical reference cursor
turns solid then you can move
waveforms vertically with Up and Down
buttons. Press SELECT again to make
trigger level cursor solid, and also use Up
and Down buttons to adjust trigger point
location Under MEASURE menu, this
button is used to confirm selected
parameters, or it is to toggle between
Cursor 1 2 under cursor measurement.
Arrow and OK buttons OK button is
used to hide display current menu
under DMM mode it is used to
confirm if current divider has been
properly connected wh
en making A
current measurement
To save current interface into
internal memory which can be
exported externally b PC which
has been loaded with the
Oscilloscope software
to open full autoset function in
which the Oscilloscope can
automatically adjust vertical
scale and horizontal timebase
based on the input signal so that
the optimal waveform can be
obtained without any manual
operation .
To open main trigger
menu
,
,
,
:
/ ;
,
.
:
,
.
: ,
+ / / / :
&
+
+
:
Shortcut Buttons Description:
SHIFT OK
y
SHIFT AUTO
SHIFT F1 F2 F3 F4