User Manual

9
9
UTD1000L
User Manual
Chapter 8 Service and Support
Updating Program
Preparation before Update
Contact UNI-T or log into our website to obtain
the latest program package, unzip the package and
apply the Oscilloscope program update system to
update the Oscilloscope so as to ensure your
oscilloscope has the latest version of firmware
issued already by UNI-T
1. Turn on your oscilloscope, press CONFIGURE
button and select system information option so
as to obtain details about the Oscillosocpe
model, hardware version, software version, etc.
2. Make sure the program package you get from
UNI T company or website has the same
model number and hardware version with the
Oscilloscope to be upd
ated. The version should
be higher than the current version.
1.The update program must have the same product
model with that of your oscilloscope.
2. The update program must be consistent with
your oscilloscope on hardware version
3. The update program version must be higher than
or equal to that of your oscilloscope.
1. Properly install the Oscilloscope software into
your PC as instructed in communication
software users manual
2.Copy the program package(extension is upp
into PC You can download from UNI-T website
and contact UNI-T company directly to get the
package.
3.Connect the Oscil
loscope to PC with USB cable,
then click to run the software choose
corresponding oscilloscope model and click
ENTER in pop-up interface, the software
interface will appear. Click Connect button
on the interface to begin communication
between PC and the Oscilloscope. With this
connection finished, there will be an indication
that USB has been connected successfully.
-
. )
.
,
【 】
【 】
Update Conditions
Program Update