User Manual

General Safety Overview
The oscilloscope is strictly designed and
manufactured as per safety/compliances: GB4793
IEC61010-1, Overvoltage CAT
V and Pollution Degree II
Please review following safety precautions to avoid
personal injury or any damage to this product or
any products connected to it. Operate the product
as specified to prevent any potential hazards. Only
the qualified personnel can perform the servicing
procedures.
Use only the insulated voltage probe, test leads
and power adaptor supplied or specified by UNI-
T for this Oscilloscope Series.
Please check multimeter test leads, oscilloscope
probe and other accessories for any
mechanical damage Please make the
replacement if any damage is found.
Remove all unused test leads, probe and other
accessories.
Insert the power adaptor first into AC socket
before connecting it to the Oscilloscope
Do not input voltages higher than 300V into
scope terminals under CAT II measuring
environment working voltage applied into
multimeter terminals must not exceed V
under CAT measuring environment.
Do not apply working voltage higher than rated
values on the Oscilloscope
Ⅲ
600 .
,
:
.
.
;
600
Warning: To avoid electric shock or fire, use
only the power adaptor specified for the
Oscilloscope and certified for the power grid by
the country of use.
Warning: If the Oscilloscope terminals are input
with voltages higher than 42V (30 Vrms) to
avoid personal electric shock
●
●
●
●
●
●
III
safety requirements for electronic measuring
instruments,
UTD1000L
User Manual
2