Specifications

17
To set up charging as follows:
Charge at 110V AC
1. Insert the red test lead into the HzV terminal and
the black test lead into the COM terminal.
2. Set the rotary switch to 110V
MAX.
3. Insert the test leads’ probe tip into the 110V AC
power supply respectively.
4. CHARGE shows on the display.
5. The charging time is around 15 mins.
6. Take the DC Voltage range as an example, the
continuous working time is
90 mins
Charge at 12-36V
1. Insert the red test lead into the HzV terminal and
the black test lead into the COM terminal.
2. Set the rotary switch to 12-36V
.
3. Place the test leads’ probe tip onto the 12-36V
power supply respectively.
4. CHARGE shows on the display.
5. The charging time is at least 30 mins.
6. The continuous working time is
90 mins
Charge by Solar Power
Automatic charging can be completed through the
built-in solar cell and a steady light source (preferably
sunlight).
Remarks:
The display indicates “0.7V” as the rated charge
voltage (us as a comparative value)
The LCD will turn off when the power is low.
When the LCD turned on or charging after 5
minutes during charging, press RESET to
display the correct current charging voltage.
When power charging has been completed,
disconnect the connection between the testing
leads and the supply power.
Operation of Hold Mode
Warning
To avoid possibility of electric shock, do not use
Hold mode to determine if circuits are without
72-9375: OPERATING MANUAL