Specifications

[e-mail]
9
D. Inductance Measurement
To test the inductance, please follow the following procedure:
1. Set the rotary switch to Lx measurement mode.
2. If the tested inductance value is unknown, use the maximum measurement position and decrease the
range step by step until a satisfactory reading is obtained.
3. Insert the test clips into the corresponding Lx input terminals.
4. Use the test clips to clip the inductance to carry out the testing.
5. The measured value shows on the display.
Remarks:
- When carrying out measurement at 2mH, short circuit the test clip first, then carrying out the
measurement. The actual correct reading is the measured reading minus the short circuit reading.
- When testing a small value inductance, it is better to use the small value jack. The Meter cannot check
the quality of the inductance.
- When inductance measurement has been completed, disconnect the connection between the testing
clips and the circuit under test and remove the testing clips away from the input terminals of the Meter.
E. Transistor hFE Measurement
To measure transistor, set up the Meter as follows:
1. Set the rotary switch to hFE measurement mode.
2. Check that the transistor is PNP or NPN type.
3. Insert the Insert the transistor to be measured to the corresponding Transistor Jack.
4. The Meter displays the tested transistor’s nearest value
Note:
- When transistor measurement has been completed, disconnect the connection between the testing
clips and the circuit under test and remove the testing clips away from the input terminals of the Meter.