Datasheet

23
Model UT58E: OPERATING MANUAL
Measurement Operation(10)
G. Capacitance Measurement (see figure 9)
( figure 9)
Warning
To avoid damage to the Meter or to the equipment
under test, disconnect circuit power and discharge
all high-voltage capacitors before measuring
capacitance.Use the DC voltage function to confirm
that the capacitor is discharged.
To avoid harms to you, never attempt to input voltages
higher than 60V DC or 30V rms AC.
To measure capacitance, connect the Meter as follows:
1. According to the size of the tested object’s leads,
select multi-purpose socket or test clip to insert into
the mA and V terminal.
2. Set the rotary switch to an appropriate measurement
position in Fcx range.
3. Insert the tested object into the corresponding jack of
the multi-purpose socket or connect the test clip to the
object being measured.
The measured value shows on the display.