Unit installation

LUMA-NET to DMX-512
In this application, Microplex or DMX is mixed with LUMA-NET and transmitted as DMX 512.
CONNECTOR OPERATION
Microplex IN Input Microplex
Microplex OUT Not Used
DMX IN Input DMX 512
DMX out Output new DMX-512
MIDI / Analog Not used
Luma-net Luma-net network
RS-232 Not Used
JUMPER LOCATIONS
P4 & 5 P7 JP6 & 7 JP8 & 9 JP10 JP11 JP12 JP13
OPEN N/A 2-3 N/A 2-3 2-3 1-2 2-3
P6 P8 JP1 DMX OUT CABLE
CLOSE CLOSE TO TERM
LUMA
POSITION 2 JP4
DIPSWITCH POSITIONS
C1 C2 C3 C4 ADDRESS 1 - 7 A8
DN DN DN UP STARTING ADDR OF LUMA-NET IN 16 INCREMENT
Allows 128 channels of Luma-net to be merged with DMX 512 in a ‘‘last action takes precedence’’ fashion.
Terminate Luma-net by closing jumper P8 only if last device on line.
Input of IF 501 is always last device at end of source DMX line.
See operator’s manual of Luma-net device for additional information.
DMX output is sent as either 64 or 128 channels, depending on the setting of switch A8.
INTERFACE UNIT
Software Revision 1.05, Version A LUMA-NET to DMX-512
NSI CORPORATION 14