Operating instructions

6. Maintenance page 55
Mercury Instruments UT-3000-E_V2.11.docx 31.07.12
Analytical Technologies
6. Maintenance
6.1 Spares and Accessories
ID # Description of Part
101-07 Particulate filter F400
101-21 Particulate filter, small version
201-04 Activated carbon cartridge
203-02G Optical cell
203-05 LC display
203-52 Microprocessor board
203-54 Detector module
203-61 UV lamp bulb (EDL)
505-38 Connector piece, for connecting UT-3000 and Auto Cal Unit
800-20 Sample bag, Tedlar, 10 l
800-25 Sample bag Tedlar, 3 l
810-01 Calibration set for manual calibration
810-02 Automatic Calibration Unit
810-10 Syringe, gas tight, 10 µl, for manual calibration
810-11 Capillary for 10 µl Syringe
810-12 Septa (pack of 10), 14 mm diam, for manual calibration set
810-13 Set of Septa (10 pcs), 6.5 mm diam, for UT-3000 Cal.Port
810-14 Ventilator for Automatic Calibration Unit
810-15 Syringe, gas tight, 25 µl, for Automatic Calibration Unit
810-16 PTFE piston for 25 µl syringe 810-15
810-17 Dryer cartridge, filled with desiccant, for Auto Cal Unit
810-18 Power supply, complete, for Automatic Calibration Unit
810-19 Closed cap for calibration cell
810-20 Septum cap for calibration cell
810-21 Saturation chamber, complete with insulating jacket
810-22 Peltier cooler block, complete with heat exchanger and Peltier element
810-62 Interface board
820-01 Protective and carrying case, for UT-3000 or Auto Cal Unit
830-01 Sample inlet dust filter, PTFE 0.25 µm, pack of 10
830-02 Valve, 2/3 way, for Goldtrap/Zeroing
830-03 Valve, 2/3 way, for heating/sampling flow
830-04 Electronic mass flow meter
830-06 Needle valve, brass, for sample flow adjustment
830-08 Needle valve, stainless steel, for heating flow adjustment
830-10 Pump, for sampling and heating gas flow
830-11 GoldTrap, complete with heating coil
830-12 Pt-100 converter module
830-14 Ventilator for UT-3000
830-15 Power supply, complete, for GoldTrap
830-16 Power supply board, for UT-3000