Operating instructions

3. Operating instructions page 22
Mercury Instruments UT-3000-E_V2.11.docx 31.07.12
Analytical Technologies
For transferring the stored data to a PC the USB output of the UT-3000 has to be connected to an
USB interface of the PC. If you want to use the RS232 output, you have to change the factory
setting (USB) first (see 2.4.1), then connect the RS232 output of the UT-3000 with a serial
interface (COM1 or COM 2) of the PC, using a 1:1 connection cable.
Two sockets are available on the instrument back panel (see also chapter 3.5.2): a 9-pin D-Sub
socket for connecting the UT-3000 to a COM-port of the PC and a USB socket for connecting
the UT-3000 to a USB port of the PC.
If USB connection is used you have to install a USB driver (CDM Driver which comes with the
Hg-Transfer software) on your PC first. The USB-driver is on the CD-ROM with the Hg-
Transfer software.
3.6.2 Sending logged data to a PC by using Hyper terminal
Select the Logger Mode menu as described under chapter 3.5.
Then following steps have to be performed on the PC (in WINDOWS):
 Select Start All Programs  Accessories  Communications  Hyper Terminal.
 Start the program Hyper Terminal.
Enter a name for the connection (for example UT-
3000), select a symbol and press OK.