Operating instructions

3. Operating instructions page 21
Mercury Instruments UT-3000-E_V2.11.docx 31.07.12
Analytical Technologies
3.6 Data Logger
The internal data logger of the UT-3000 can store data of up to 5000 measurements. The
maximum logging duration depends on the set sample volume, for a sample volume of 10 l the
logging capacity will be approximately 60 days.
If F3- Data Logger is selected in the main menu, the Logger Menu is displayed.
F1- Logger Mode: the logger function can be switched on or off.
F2- Show Logdata: the logged readings are displayed as a bar graph. The graph can be scrolled
with the F3 and F4 keys.
F3- Send Logdata to PC: If a PC is connected to the RS232 output of the Ultratracer and a data
transfer program (e.g. Hyper Terminal) has been started, data are sent to the PC after pressing the
F3 key (see chapter 3.6.2).
F4- Clear Logdata: the logged and stored data are erased.
3.6.1 Start logging of measurement data
After the data logger has been activated the measurement data are automatically logged whenever
the measurement mode is active. The status of the logger is indicated on the display (F1- Logger
Mode ON/OFF).