Operating instructions

page 2
Mercury Instruments UT-3000-E_V2.11.docx 31.07.12
Analytical Technologies
General information for safe operation
Caution:
WARNING: While operating the UT-3000 or the Automatic Calibration
Unit, parts of its interior are under high voltage. UV-beams are produced
inside the instrument. If safety regulations are ignored physical and/or
material damages could occur. Only qualified personnel should be
authorised to operate the UT-3000 and its accessories.
Conditions for correct function of the UT-3000 system are careful
storage and proficient operation and maintenance.
 Do not operate instrument if damaged.
 When connecting the UT-3000 to a power source please note the related safety
regulations.
 The UT-3000 or the Automatic Calibration unit should be operated from the
type of power source indicated on the rating plate.
 Make sure that plugs and power cord are not damaged.
 Only operate the UT-3000 and its accessories on a stable and dry surface. The
interior of the instrument should never get moist or wet. In case it happens,
consult an expert.
 Regulations for prevention of accidents are to be followed.
 Before opening the UT-3000 or the calibration device disconnect it from its
mains supply.
 Repair and maintenance on the opened and powered instrument must only be
done by qualified personnel.
 The UT-3000 is dedicated for the measurement of mercury concentrations in
air and gaseous samples. Do obey the related dangers while working with
toxic or harmful substances. Do not operate the UT-3000 in hazardous areas
or for measurement of flammable or explosive gases. A special version for
mercury measurement in natural gas is available. This must be explicitly
indicated on the instrument and in the according documentation which comes