Operating instructions

2. Installation page 11
Mercury Instruments UT-3000-E_V2.11.docx 31.07.12
Analytical Technologies
2.2 Electrical power supply
The voltage of the power source has to be the same as the operation voltage indicated on the
rating plate of the UT-3000. One end of the included power cord has to be connected to the
power cord receptable on the back of the UT-3000. The opposite end has to be plugged into an
appropriate power outlet. For operation turn on the UT-3000 by pushing the power
switch on the back plate to position I .
F IGURE : R EAR PANEL OF UT-3000
2.3 Operation and display components
The UT-3000 features a waterproof IP66 keypad and a graphic LCD with background
illumination for comfortable operation.
2.4 Connection of the electrical output
2.4.1 Serial Data output (USB / RS 232)
To read out data from the built-in data logger or measurement results in realtime connect the UT-
3000 with a PC. The serial input of the PC (COM1 or COM2) has to be connected to the USB-
port on the rear panel of the instrument using an appropriate cable (part no. 202-07a). Below the
USB-port there is also available a 9-pin DSUB-socket labelled “RS232”. This socket is normally
used for the controlling of the automatic calibration device option. But by manually switching an