Operating instructions

2. Installation page 10
Mercury Instruments UT-3000-E_V2.11.docx 31.07.12
Analytical Technologies
2. Installation
2.1 Preparation for Operation
The UT-3000 is unpacked and placed on a flat surface (e.g. table). The handle can be adjusted
in several steps in order to be used for carrying the instrument or as a base to position it on a
bench (only if applicable; there is also a version for 19” rack mount available).
F IGURE : A DJUSTMENT OF CARRYING HANDLE
The sample inlet filter (0.45 µm PTFE) is unpacked. Insert the filter into the filter holder on the
front panel of the instrument and push it carefully over the white nozzle in the center of the filter
holder. Turn the filter slightly to get a tight connection.
 The printed side of the filter shows towards the operator.


 Never operate the instrument without a sample inlet filter installed !
Sample Filter
always in place!