Datasheet

To set knob.
Please place function knob to “
V ” measurement gear.
To select key functions.
To set measured DC voltage to initially set value. Initially
set automatic range can be set to relative range by
pressing REL△ key.
●To connect load.
To disconnect probe and measured circuit then remove
probe from input end after all measurement operations.
2. AC voltage measurement (V～) (shown in Figure 4)
Warning: Clamp meter cannot be used for
conductive article of which voltage exceeds AC/DC
600V.
●To set knob.
Please place function knob to”
V ”
measurement gear.
●To select key functions.
To set measured DC voltage to initially set value.
Initially set automatic range can be set to relavite range
by pressing REL △ key.
●To connect load.
To disconnect probe and measured circuit then remove
probe from input end after all measurement operations.