Datasheet

1. Please inspect clamp meter and probe before
use to avoid damage or abnormal use. Please do
not use the clamp meter again if probe or shell
insulation is damaged obviously with LCD display
failure or clamp meter cannot operate normally.
2. It is strictly prohibited to use clamp meter before
covering rear cover and battery cell to avoid electric
shock.
3. Fingers cannot exceed probe forehand during
measurement. Do not touch nude electric wires,
connector, unused input end or circuits during
measurement to avoid electric shock.
4. Function switch must be in correct position before
measurement. It is strictly prohibited to change
gears during measurement to avoid damage of
clamp meter.
5. Do not exert at least 600V between terminal of
clamp meter and grounding to avoid electric Shock or
damage of clamp meter.
6. To operate the instrument carefully under DC 60V
or AC 30V to avoid electric shock.
7. Do not measure voltage or current which is more
than permissible input value. Be sure to place
function range switch to the maximum range
position if scope of measured value cannot be
determined. Be sure to cut off circuit power and
discharge all capacitors before ON/OFF
measurement of online resistance, diode or circuit.
To disconnect probe and measured circuit then
remove probe from input end of clamp meter and
cut off power after measurement.
8. To replace battery in a timely manner during
display of LCD display to guarantee high
measurement precision. To take battery out if clamp
meter has not been used for a long time.
9. Please do not alter internal wiring of clamp meter
randomly to avoid instrument damage and safety
danger.
10.Do not store or use clamp meter in environment
in high-temperature, high-humidity, combustible,
explosive and strong current magnetic environment.
11.Please clean the instrument shell by soft cloth
and neutral detergent during maintenance. Do not use
abrasive or solvent to avoid shell corrosion which may
cause instrument damage and safety danger.