Datasheet

Warning: Be sure to cut off circuit power and discharge
residual charge of all capacitors before load connection.
●To set knob.
Please place function knob to” Ω, ， ，
“measurement gear.
●To select functions.
To select capacitance detection by pressing SELECT
key;
●To connect load.
Measurement notice:
1)Be sure to reset by pressing REL key before
measurement.
2)Instrument reading will delay for about 30 seconds
normally when measuring large capacitance.
To disconnect probe and measured circuit then remove
probe from input end after all measurement operations.
7.Frequency measurement (Hz) (shown in Figure 9)
Warning: Clamp meter cannot be used for conductive
article of which voltage exceeds AC/DC 600V.
●To set knob.
Please place function knob to “Hz”measurement gear.
●To select key functions.
●To connect load.