Installation guide

[e-mail]
8
We recommend you to read this chapter carefully to familiarize with application.
Connect the RS-232 power cord or USB lead. Turn on the oscilloscope and activate the
PC E- UT 2000 Series Digital Storage Oscilloscope software. Enter the following screen:
USB Interface Controls
If controlling the oscilloscope via the USB interface, follow the steps below:
1. With the equipment selection knob on the real-time control panel, select USB.
2. Click the [Equipment ON/OFF] knob to turn it on. When the indicator lights up the
function is ON. When the indicator lights off the function is OFF.
3. Click the [Data Transmission] knob to turn it on. When the indicator lights up the function
is ON. When the indicator lights off the function is OFF.
4. Click the [Data Transmission] knob to turn it off. When the indicator lights up the
function is ON. When the indicator lights off the function is OFF.
5. Click the [Data Interface] knob to pop up the following screen.