Installation guide

[e-mail]
3
1. PCE-UT 2000 Series Digital Storage Oscilloscopes Introduction
The PCE-UT 2000 Series Digital Storage Oscilloscope software is written for PCE-
UT2000 Series digital storage oscilloscopes. With this software you can carry out
communication between a computer and an oscilloscope through serial or USB, and in
turn perform remote control. This software also provides testing, waveform and sampling
data reading functions to facilitate further signal testing and analysis.
Equipment Requirement Minimum
Oscilloscope PCE-UT2000 Series
PC IBM-compatible PC, Windows 2000/XP OS, 16MB RAM,
4X optical drive or better SVGA display or better
RS-232 Power Cord The connection terminals of the oscilloscope and PC
must match
USB Lead