Installation guide

[e-mail]
26
5. Chapter Four: System Prompts and Troubleshooting
System Prompts
Time out prompt: Check the serial configuration or check whether the equipment is
properly connected.
Time out prompt: Check the USB configuration or check whether the equipment is
properly connected.
SCAN prompt: SCAN will perform single transmission. Please carry out single refresh.
Continue?
Are you sure you want to exit Virtual Instrument? A prompt will ask you if you wish
to close the software.
Troubleshooting
1. If the system prompts you to check serial or USB configuration when you enter
[Equipment ON/OFF], take the following steps:
 Check whether the oscilloscope power plug is properly connected.
 Check whether oscilloscope ports match the testing and control software setups
(Factory default: RS-232 baud rate 4800).
 Check whether the cable connection between module and PC is in order.
 After carrying out the above checks, restart the software to continue operation.
In this direction will find a vision of the measurement technique:
http://www.industrial-needs.com/measuring-instruments.htm
NOTE: "This instrument doesn’t have ATEX protection, so it should not be used in potentially explosive
atmospheres (powder, flammable gases)."