User Manual

Table Of Contents

UT108/109 OPERATING MANUAL

I. Temperature Measurement (UT109only)(See gure 12)

Warning

To avoid harm to yourself, do not input higher than DC 60V or AC 30V voltages.

To measure temperature, connect the Meter as follows:

1. Set the rotary switch to ℃℉. Press BLUE button to select temperature measurement

mode.

2. Insert the temperature probe into the input terminal as shown on the gure 12.

3. Place the temperature probe to the object being measured.

After few seconds, the measured value shows on the display.

4. Press BLUE button to toggle between ℃ and ℉ temperature.

Note

● To avoid measurement error especially low temperature measurement, the operating

temperature must not exceed 18 ~ 23℃.

● When temperature measurement has been completed, disconnect the connection

between the temperature probe and the object being measured, and remove the

temperature probe away from the input terminals of the Meter.