User manual

42
UNI-T
®
UT4000 User Manual
Table 2-19 Utility functions menu (1)
Function Menu Setup Explanatory Note
System configuration Auto calibration
System information
Clear information
RTC setup
Factory setup
Run auto system calibration.
Display information like oscilloscope
software and hardware versions.
Clear all saved reference waveforms and
front panel status setups.
Set time and date.
Recall factory setup.
Interface setup Language
Interface style
Menu display
Grid brightness
Select one of the languages.
Classic, traditional, modern.
Set the waiting time for automatic menu
shutoff ⎯ 5s, 10s, 20s and manual.
Adjust the brightness of the waveform style
zone with the multifunction control knob.
Pass check Allow testing
Output
Turn the testing function on or off (this
function is disabled in the dual time base
and roll operation modes).
Set to output signal to pass or fail. The
signal is output through the PASS/FAIL
interface at the rear of the oscilloscope.
Table 2-19 Utility functions menu (2)
Function Menu Setup Explanatory Note
Signal source
Display message
Run
Stop setup
Template setup
Designate testing type as CH1 or CH2.
Open or close the test result.
Run or stop the “PASS/FAIL” test.
Set the stop testing conditions.
Create a module of test conditions.
Recording waveform See Table 2-21 Setup for waveform recording.
Next page
1/2
⎯
Go to the next page.
Table 2-20 Utility functions menu (3)
Function Menu Setup Explanatory Note
Frequency counter On
Off
Turn the frequency counter on.
Turn the frequency counter off.
⎯
Next page
2/2
⎯
Return to the previous menu.