User manual

37
UNI-T
®
UT4000 User Manual
Setting Up the Display System
As shown below, the [DISPLAY] button in the control zone is the function key for the
display system.
Figure 2-21 Function key for the sampling system (display).
Press the [DISPLAY] button to pop out the setup menu shown below. You can use this
menu to adjust the display mode.
Table 2-15 Display menu
Function Menu Setup Explanatory Note
Type YT
XY
Operating mode of the oscilloscope.
X-Y is the display mode; CH1 is X input, CH2
is Y input.
Format Vector
Dot
Sampling points are linked for display.
Sampling points are directly displayed.
Grid Full
Grid
Crosshair
Frame
Set the grid display mode of the waveform
zone to full, grid, crosshair or frame.
Duration Auto
1s
2s
5s
Infinite
Waveform on the screen is refreshed at normal
rate.
Waveform on the screen is maintained for 1
second and then refreshed.
Waveform on the screen is maintained for 2
seconds and then refreshed.
Waveform on the screen is maintained for 5
seconds and then refreshed.
Waveform on the screen remains on display.
New data will be added continuously until this
function is disabled.
Intensity 1-32 In “quick acquisition” mode, intensity of the
waveform can be adjusted with the
multifunction control knob.