User manual

14
UNI-T
®
UT4000 User Manual
Chapter 2 ⎯ Instrument Setups
You should be familiar with basic operation of the vertical controls, horizontal controls
and trigger system menu of your UT4000 oscilloscope by now. After reading the last
chapter, you should be able to use the menus to set up your digital storage oscilloscope. If
you are still unfamiliar with these basic operation steps and methods, please read Chapter
1.
This chapter will guide you through the following :
 Setting up the vertical system ([CH1], [CH2], [MATH], [REF], [OFF], [VERTICAL
POSITION], [VOLTS/DIV])
 Setting up the horizontal system ([MENU], [HORIZONTAL POSITION
],
[SEC/DIV
]
 Setting up the trigger system ([TRIGGER LEVEL
], [MENU], [50%], [FORCE])
 Setting up the sampling method ([ACQUIRE])
 Setting up the display mode ([DISPLAY])
 Save and transfer ([STORAGE])
 Setting up the utility function ([UTILITY])
 Automatic measurement ([MEASURE])
 Cursor measurement ([CURSOR])
 Using the auto setup, run/stop buttons ([AUTO], [RUN/STOP])
 Logic analyzer [LA]
 Digital multimeter [DMM]
It is recommended that you read this chapter carefully to understand the various
measurement functions and system operation steps of your UT4000 Series Oscilloscope.