Instruction manual

19
(12) Close down the top roller bracket and clip
the pressure arm into place.
(13) Apply a medium amount of
pressure to the drive roller
(14) Remove the gas nozzle and contact tip
from the front end of the mig torch.
(15) Press and hold the inch wire button to
feed the wire down the torch cable through
to the torch head.
(16) Fit the correct size contact tip over
the wire and fasten tightly into the tip
holder.
(11) Feed wire over the drive roller into
the outlet guide tube, Push the wire
through approx 150mm. Use a Knurled
Drive Roller of the correct size
Note: Pictures may vary from your model machine
(17) Set welding parameters using
the voltage and wire feed controls on
machine
(18) Set welding parameters using the
voltage and wire feed controls on torch
OR
Wire Speed / Voltage selection button.
NOTE: Press for 2 seconds to activate or disable
Wire Speed / Voltage + & -buttons
Continued set up for MIG with Gasless for UNI-MIG-MIG210/250 DIGITAL MTS
(8) Connect the weld power cable plug inside the wire feeder to the output socket NO GAS, and tighten it.
(9) Fit the correct size Knurled drive roller for Gas Less Flux Core wire.
(10) Place the Wire Spool onto the Spool Holder - Note: the spool retaining nut is Left Hand thread.
Snip the wire from the spool being sure to hold the wire to prevent rapid uncoiling. Feed the wire into
the wire feeder inlet guide tube through to the drive roller.
(11) Feed wire over the drive roller into the outlet guide tube, Push the wire through approx 150mm
(12) Align the wire into the groove of the drive roller and close down the top roller making sure the wire is in
the groove of the bottom drive roller, lock the pressure arm into place.
(13) Apply the minimum amount of pressure to the drive roller to drive the wire without slippage.
(14) Remove the gas nozzle and contact tip from the torch neck,
(15) Press and hold the inch button to feed the wire through to the torch neck, release the inch button when
the wire exits the torch neck.
(16) Fit on oversized contact tip (one size lager than wire used) and feed the wire through it, screw the
contact tip into the tip holder of the torch head and nip it up tightly.
(17) Set the welding parameters using the wire feed and voltage control knobs on power source
OR
(18) Press and hold wire speed / voltage button and hold down for approx two seconds to active
torch control. Pressing the button allows voltage display U or wire speed S to be selected, control of the
parameters can then be regulated by the + or - buttons on the torch handle. Pressing and holding down
wirespeed/ voltage button for approx 2 seconds after adjustments have been made locks these settings
that have been selected. to unlock repeat steps listed above.