Instruction manual

10
INSTALLATION & OPERATION
Please install the machine strictly according to the following steps.
The protection class of this machine is IP21S, so avoid using it in wet areas.
Connection of Input Cables
Primary input cable is supplied with this welding equipment. Connect the primary input cable with power
supply of required input voltage. Refer to data plate on machine for Input voltage, IMAX and IEFF.
Before MMA (Stick)Welding:
Disconnect the cable with twist lock connector
that is attached to the wire feeder from the output
socket’s “GAS” “NO-GAS” on the backboard.
If cable is not disconnected welding voltage is
present on MIG torch and can cause arcing or
ash.
WARNING!