Instruction manual

UNI FLAME AUTOLIFT
Mod.A
LEGENDA:
LED 1 = Thermal protection
LED 2 = Trigger normal – Manual welding
LED 3 = Trigger latch – Automatic welding
LED 4 = Stich welding
LED 5 = Spot welding
S1 = Menù. To select welding parameter on the display
S2 = Mode. To select welding type on the led welding parameter
DISPLAY = Show welding parameter
ENC = Encoder
4.1 WELDING TYPE
Pushing S2 (mode) it’s possible to select the type of welding
needed on the led 2,3,4 and 5
A) MANUAL (led2):
Pushing the switch on the torch it is possible start to weld,
releasing it shall stop the welding.
B) AUTOMATIC (led3):.
Pushing the switch on the torch it is possible to begin welding
continuously, the switch must be pushed more time in order to
stop the process.
C) STICH WELDING (led4):
Pushing the switch on the torch the machine weld for the
selected time (Time on regulation as in 4.2.5), then will stop for
the selected time (Pause time regulation as in 4.2.6). The
machine will repeat automatically the cycle.
D) SPOT WELDING (led5):
Pushing the switch on the torch the machine weld for the
selected time (Time on regulation as in 4.2.5), after this period it
will stop. It is necessary to re-push the button in order to repeat
the mentioned function.
4.2 WELDING PARAMETER – Display
Pushing S1 (menù) button it is possible to select the parameter
used during the welding, increasing or decreasing the values
using the knob of the encoder.
LEGENDA:
Don’t press the “MODE” button while you are welding.
It is possible to reset the PCB’s original parameter (DEFAULT)
following these steps:
Turn off the welding machine, pushing the on/off switch
(position 0). Push S1 and S2 button. Turn on the welding
machine, keeping pushed for three seconds
Mod.B
LEGENDA:
LED = Thermal protection
S1 = Menù. To select welding parameter on the display
DISPLAY = Show welding parameter
ENC = Encoder
4.1 WELDING TYPE
A) MANUAL:
Pushing the switch on the torch it is possible start to weld,
releasing it shall stop the welding. (Time ON=0)
D) SPOT WELDING:
Pushing the switch on the torch the machine weld for the
selected time (see 4.2.5 how to regulate it), after this period it will
stop. It is necessary to re-push the button in order to repeat the
mentioned cycle.
4.2 WELDING PARAMETER – Display
Pushing S1 (menù) button it is possible to select the parameter
used during the welding, increasing or decreasing the values using
the knob of the encoder
LEGENDA:
It is possible to reset the PCB’s original parameter (DEFAULT)
following these steps:
Turn off the welding machine, pushing the on/off switch
(position 0). Push S1 button. Turn on the welding machine,
keeping pushed for three seconds