User Manual

SPEAKER RECEIVERS
1. Remove the Battery Door by pushing the Battery Door Lock.
2. Insert 6 pieces of ‘AA’ size ALKALINE batteries into the
battery compartment with correct polarity under the speakers,
then replace the door of battery compartment, or connect the
provided AC/DC 9V Adaptor to the DC input jack under the
speakers, then plug it to the wall AC outlet. Note that this
Speaker will not charge any batteries.
OPERATION
1. Turn on the audio source to which the transmitter is connected with. The Signal LED on
transmitter will light up.
2. Select a channel of the transmitter for best performance in your location.
3. Press the “POWER” button on the speaker to turn on the speaker. Press the “TUNE” button to
get the best tuning reception in the speakers. When the button is pressed, frequency tuning
starts automatically and it stops when a signal is detected.
4. Volume can be increased from the speaker by pressing “ + ” button or decreased by pressing the
button “ – “.
5. Tuning
a) Keep a distance of approximately 23 feet between speaker and transmitter, and then
press the button “ TUNE “ button for best tuning reception.
b). Once the frequency is jammed, select another channel on the transmitter, then press
“ TUNE “ button again.
6. Switching Off
a) For protection of the transmitter and power saving, the transmitter will cut off
automatically if there is no/weak operation input signal from audio source for 4 about
minutes. In other words, if the signal comes back, the transmitter will work again
automatically.
b) Press the “POWER” button to turn off the speaker and the LED light goes off.