SP3290 900MHz Wireless Outdoor/Indoor Speakers System User’s Manual Please read before using the equipment
INTRODUCTION This 900 MHz wireless speaker system uses latest wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any audio source such as Radio, TV, VCR, Hi-Fi and CD/MP3/VCD/DVD player. Without complicated wiring and installation with your Audio/Video equipments and rear channel amplifier, the system enables you to enjoy thrilling, lifelike sound in minutes. FEATURES 1.
COMPONENT IDENTIFICATION TRANSMITTER 1. Antenna Tube 2. Power LED 3. Signal LED 4. Audio Cord 5. CD Jack 6. Channel Selector SPEAKER RECEIVERS 7. Power LED 8. Power ON/OFF 9. Volume Up 10. Volume Down 11. Auto Scan 12. Ligth ON/OFF 13. Battery Compartment P.
INSTALLATION TRANSMITTER 1. Insert the antenna tube into the antenna wire. 2. Connect the supplied AC/DC power adaptor to an electrical wall outlet. 3. Plug the AC/DC power adaptor in the DC jack located on the rear of the transmitter. 4. When the AC adaptor is plugged in, the green POWER LED illuminates. If the green POWER LED does not illuminate, make sure the adaptor is plugged in. 5.
2. Press POWER button and turn the speakers ON. up in blue. The POWER LED will light Switch off the speakers by pressing the POWER button on the speaker, and the LED will be off. OPERATION 1. Turn on the audio source (TV or audio component) to which the transmitter is connected with. The blue Signal LED on the transmitter will light up. 2. Select the channel (1 or 2) of the transmitter for best performance in your location. 3. Press the “POWER” button on the speaker to turn on the speaker.
NOTE : a). Keep a distance of the speaker up to 7 meters apart from the transmitter, and then press “AUTO SCAN” button for the best reception. b) Whenever you find frequency jam, move your channel switch from one channel to the other channel (there are two channels for selection) on the transmitter, and then press the “AUTO SCAN” button again. 6. You should now be able to place the speakers freely from room to room without disruption.
TROUBLE SHOOTING NO SOUND - Ensure the AC/DC adaptor is fully inserted into the AC outlet and the power connection input on the transmitter. - Ensure the speaker is switch ON. - Speaker’s battery capacity is too low, replace with new batteries or connect the AC/DC adaptors to the speakers. - Ensure the TV or audio component is ON. - The connected audio / video equipment is not playing. Start playing the equipment. - The volume of speaker is too low, adjust the volume to an appropriate level.
TECHNICAL SPECIFICATIONS Transmission Mode : UHF Carrier Frequency : 900 MHz Operation Voltage : Transmitter, DC 12V 200mA Speaker, 6 X ‘AA’ size Alkaline batteries or DC 9V 1A adaptor.
