User's Manual

P. 2
-
Change the position of the channel selector on the transmitter. You
must then press the “AUTO SC
AN” button on the speakers.
-
Battery capacity is too low. Replace with the new battery.
- Ensure the volume level of
speakers is adjusted properly.
-
The speaker is too far away from the transmitter, move it closer.
-
The input level of the audio signal is too low. Turn up the volume of the
audio source equipment.
TECHNICAL SPECIFICATIONS
Transmission Mode : UHF
Frequency Range :
Operation Voltage : Transmitter, DC 12V 200mA
Speaker, 6 X ‘AA’ size Alkaline batteries or DC
9V 1.2A adaptor.
Remote Control, 2 X “AAA” size
A
lkaline
batteries (not included).
Frequency Response : 40Hz – 12KHz
Distortion : 1%
S/N Ratio : 65dB (typical)
Channel Separation : 50dB (typical)
Operation Distance : Up to 50 meters (open area)
Output Power : 2 x 5Watts (RMS)
WARNING : Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that
may cause undesired operation of the device.
This device must be used with the AC/DC adaptor supplied in the
package.
912.0 MHz, 913.0 MHz