User's Manual

P. 9
TROUBLE SHOOTING
NO SOUND
- Ensure the AC adaptor is fully inserted into the AC outlet and the
power connection input on the transmitter.
- Ensure the speaker is switch ON.
- Speaker’s battery capacity is too low, replace with new batteries or
connect the AC adaptors to the speakers.
- Ensure the TV or audio component is ON.
- The connected audio / video equipment is not playing. Start
playing the equipment.
- The volume of speaker is too low, adjust the volume to an
appropriate level.
DISTORTED
- Press the “SCAN” button on the speakers until matching the
frequency of the transmitter.
- Change the position of the channel selector on the transmitter.
You must then press the SCAN button on the speakers.
- Battery capacity is too low. Replace with the new battery.
- Ensure the volume level of speakers is adjusted properly.
- The speaker is too far from transmitter, move closer.
- The input level of the audio signal is too low. Turn up the
volume of the audio source equipment.
P.10
TECHNICAL SPECIFICATIONS
Transmission Mode : UHF stereo
Carrier Frequency : 900 MHz
Operation Voltage : Transmitter, DC 12V 200mA
Speaker, 6 X ‘AA’ size Alkaline batteries or DC
12V 500mA adaptor
Frequency Response : 40Hz – 12KHz
Distortion : 1.5%
S/N Ratio : 50dB (typical)
Channel Separation : 30dB (Typical)
Operation Distance : Up to 50 meters
Output Power : 2 x 3W (RMS)
WARNING: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment. Operation is subject to
the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of
the device.