User's Manual

P. 5

SPEAKER RECEIVERS

1. Insert 6 pieces ‘AA’ size ALKALINE

battery into the battery compartment with

correct polarity at the rear of the speakers

or connect the 12V power adaptor to the

DC input jack on the rear of each speaker,

then plug it to the wall AC outlet.

2. Switch on the speakers by turning up the VOLUME ON / OFF knob

towards ON direction. The POWER / STEREO LED will light up.

Switch off the speakers by turning down the VOLUME ON/OFF knob

towards OFF direction until a “click” sound is heard.

OPERATION

1. Turn on the audio source (TV or audio component) to which the

transmitter is connected with. The LED on transmitter will light up.

2. Select the channel 1 or 2 of the transmitter for best performance in your

location.

3. Select the L/Mono/R selector on the speaker receivers, one to L and the

other to R for the best stereo reception.

Ã In case the audio device only provides Mono audio signal, select the

MONO/ST selector to MONO for the best mono reception.

4. Turn on the ON/OFF VOLUME knob on the speaker and adjust the

volume to the desired listening level.

P. 6

5. Push the “SCAN” auto-tuning button to get the best tuning reception in

the speakers. When the button is

pressed, frequency tuning starts

automatically and it stops when a

signal is detected. The POWER /

STEREO LED will change from red

to green.

A). Keep a distance of the speaker up

to 7 meters apart from transmitter, and then press “SCAN” auto-tuning

button for best tuning reception.

B) Whenever you find frequency jam, move your channel switch from

one channel to the other channel (there are two channels for

selection) on the transmitter, and then press the “SCAN” auto-tuning

button again.