RF 900 MHz STEREO WIRELESS SPEAKER SYSTEM Owner’s Manual Please read before using this equipment
INTRODUCTION The 900 MHz stereo wireless speaker stern uses latest wireless technology that enable you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any sound source such as CD, TV VCR, Hi-F and radio. Without complicated wiring and installation with your and rear chenille amplifier, the system enables you to enjoy thrilling, lifelike sound stereo in minutes. FEATURES 1. 900 MHz RF technology. 2.
INSTALLATION TRANSMITTER 1. Screw the antenna into the transmitter. 2. Connect the supplied AC power adapter to an electrical wall outset. 3. Plug the AG power adapter in the DC jack located at the rear of the transmitter. 4. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV, HI-PHI, VCR, CD, Radio tape recorder of to headphone / earphone jack with the connector provided.
SPEAKER RECEIVER 1. Insert & pieces of ‘D’ Size ALKALINE battery or 1 pack of LEAD ACID rechargeable battery (optional) into the battery compartment at the rear of the speaker. Make sure batteries are placed at the correct polarity. Another power supply will be available with after making connection of 9V 1.5A power adapters 1 the wall AC outlets and the DC input Jacks at the red of each speaker. 2. Turn on the volume control and set to mid level at the front panel of the speaker.
] 6. Whenever you find frequency jam, re-adjust your tuning of transmitter, until the speakers automatically indicate the best stereo reception. Ll Note: You should now be able to place the speaker freely from room to oom without disruption. If disruption should occur (signal breaks up), Press auto-tuning key on front panel for best stereo reception.
CHARGING THE RECHARGEABLE BATTERY (OPTIONAL) 1. Insert the a specified Lead Acid Rechargeable Battery(please contact your dealer)into the battery compartment properly {please refer to diagram A), 2. Place the battery cover properly (please refer to diagram 8). 3. Plug the AC power adapter in the DC jack located on the rear of the speakers, 4. Turn off the speakers. 5. LED indicator at the back of speaker will be ON during the process of battery charging. 6.
TROUBLE SHOOTING NO SOUND DISTORTED Ensure the AC adapter is fully Inserted into the AC outlet and inch the power connection input an the transmitter. Ensure the speaker's ON/OFF switch Is in the ON position. Speaker's battery may be 100 low. Ensure the TV or audio component is ON and tuned to a channel with audio. Adjust the volume control on the speaker to turn up the volume. The connected audio / video equipment is not playing. Start playing the equipment.
