Owner's Manual

4
COMPONENT IDENTIFICATION
1 RF transmitter
2 RF receiver headphones
3 Power On/Off switch
4 Power On indicator light
5 Rechargeable batteries (LR03/AAA size)
6 Charge contacts
7 12 V 200 mA mains adapter
8 Jack plug adapter (3.5 mm/6.3 mm diameter)
9 RCA socket audio adapter
10 Operating indicator light
11 Charge indicator light
12 Audio connection cable with 3.5 mm jack plug
13 Volume control knob (VOL)
14 AUTO SCAN indicator
15 AUTO SCAN button
16 Channel selector (CHANNEL 3 2 1)
17 DC IN connector
18 Audio input cable
5
INSTALLATION
TRANSMITTER
1. Connect the mains adapter provided to an electrical outlet.
2. Connect the mains adapter cable to the DC IN input connector located on
the transmitter rear panel.
3. A cable is provided from the transmitter rear panel that can be
connected to
the audio outputs (Left and Right) present on a TV set, Hi-Fi system, VCR or
radio-cassette player, or to a headphones/earphones output using the connector
supplied.
The red Auto On indicator light will light up as soon as you have connected the
power adapter to the mains outlet and the audio cable to a signal source. If the Auto
On indicator light remains off, switch on the audio source and increase its output
level until the red indicator light comes on.
RECEIVER HEADPHONES
1. Open the cover of the battery compartment located on the right hand receiver
headphone.
2. Insert two rechargeable LR03/AAA size batteries taking care to ensure
correct polarity.
3. Close the battery compartment cover.