Owner's Manual

ManualsBrandsUni-Art Precise Products ManualsAudio EquipmentWIRELESS HEADPHONE RECEIVER

Cordless Stereo 900MHz

Headphone System

User's Manual

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including

interference that may cause undesired operation.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR

ANY RADIO OR TV INTERFERENCE CAUSED BY

UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.

SUCH MODIFICATIONS COULD VOID THE USER’S

AUTHORITY TO OPERATE THE EQUIPMENT.

INTRODUCTION

This 900 MHz compact stereo headphones takes advantage of the very latest

advances in wireless transmission technology so that you can listen to music or the

sound from your TV set both in the house and outdoors. All you have to do is

connect the transmitter to any audio source: DVD player, CD player, TV set, VCR,

Hi-Fi system or radio (range 50 meters).

Summary of content (6 pages)

PAGE 1
Cordless Stereo 900MHz Headphone System This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
PAGE 2
FEATURES COMPONENT IDENTIFICATION 1. Auto Scanning system on headphone 2. Phase Lock Loop (PLL) transmission system on transmitter 3. Automatic battery recharging (batteries supplied). 4. 900 MHz RF technology. 5. RF technology leaves you completely free to move around. 6. Transmission is not restricted solely to line of sight. 7. Rechargeable receiver headphones. 8. Charger built into the transmitter. 9. High quality stereo sound that is virtually interference-free. 10.
PAGE 3
COMPONENT IDENTIFICATION INSTALLATION 1 RF transmitter 2 RF receiver headphones 3 Power On/Off switch 1. Connect the mains adapter provided to an electrical outlet. 4 Power On indicator light 2. Connect the mains adapter cable to the DC IN input connector located on 5 Rechargeable batteries (LR03/AAA size) 6 Charge contacts 7 12 V 200 mA mains adapter 8 Jack plug adapter (3.5 mm/6.
PAGE 4
OPERATION NOTE: You should then be able to move around freely from one room to another without 1. Switch on the sound source (TV set or audio component) that the transmitter is connected to. any interference. If interference does occur (interruptions in the signal), press the "Auto Scan" button once to find a better reception channel. 2. Place the headphones On/Off switch in the On position. 3. Place the headphones on your head and adjust the volume to obtain the A desired sound level. 4.
PAGE 5
WARNING: REPLACING BATTERIES Never attempt to recharge conventional dry cells. Rechargeable batteries have a long service life. If it is however necessary to replace Never use another type of battery or non-rechargeable batteries to replace the them, proceed as described below: rechargeable (LR03/AAA) batteries supplied. When the headphones are not in use, move the switch to the OFF position to avoid damaging the batteries. Carefully The batteries must always be fully charged before use.
PAGE 6
TECHNICAL SPECIFICATIONS TROUBLE SHOOTING NO SOUND Transmission mode : UHF stereo Carrier frequency : 900MHz Operating voltage : Transmitter – 12 V 200 mA Receiver - Ensure that the mains adapter is pushed fully into the power outlet and that its cable is properly connected to the DC IN 12V connector on the – 2.4 V (two rechargeable batteries, LR03/AAA size) Frequency response : 30 Hz – 11 KHz Distortion : <1.