User Manual

6. This headphone can be used as a regular wired headphone by connecting your Audio source to
the headphone jack shown below.
IMPORTANT
1. Switching Off
a) For protection of the transmitter and power saving, the transmitter will be switched to
standby (LED will change to BLUE) automatically if there is no audio source signal for
approximately 5 minutes. If the audio source signal returns, the transmitter will be
automatically switched on (LED will change to AMBER). Then, power on the headphone
again to listen the music.
b) The headphone will be switched off automatically if there is no signal from the transmitter
for 5 minutes.
2. Make sure the headphone is turned off when charging is in process.
3. Use only the included rechargeable AAA batteries. When the headphone is not in use, turn the
headphone OFF.
4. To ensure a long service life, fully charge the batteries before using the headphone for the first
time. According to the capacity of the rechargeable battery included, the battery charging
process will take approximately 5 hours.