User Manual

HEADPHONE RECEIVER
1. Turn on the headphone by pressing the Power button for about 1 second. The LED will light up
in RED. The RED LED
will be change to GREEN until audio signal link between transmitter and
receiver is established.
2. Place the headphone on your head. To obtain the desired sound level, adjust the volume control
on the headphone
.
3. If interference or poor signal reception occurs, the headphone will be muted and the LED will
change to RED, searching for another channel will be run automatically.
4. When the batteries of headphone are at low level, the LED
will blinks in RED. There will be
beeping sound from the headphone in every minute to indicate the last 5 minutes of working,. A
beep sound in each of the first 4 minutes, and 2 beep sound in the last minutes and then it will
automatically switch off.
5. To charge the batteries in the headphone, turn OFF the headphone by pressing the Power button.
Place the headphone on the top of transmitter. The charging process begins automatically, and
the LED on the transmitter will light in PURPLE when the charging contacts of transmitter and
headphone are matched successfully. When the charging process is completed, the LED will be
change to BLUE
Note : For the initial use, please charge the batteries for 7 hours. If the headphone is not
in use, please place it back on the transmitter.