User Manual

HEADPHONE RECEIVER
1. Turn on the headphone by pressing the Power button for about 2 seconds. The LED will light up
in RED, and then change to GREEN when Audio Signal link between Transmitter and Headphone
Receiver is established. If no Audio Signal is detected, this LED will glow in RED constantly.
2. Adjust the size of the Headband, place the Headphone on your head. To obtain the desired sound
level, adjust the Volume Control on the Headphone.
3. If interference or poor signal reception occurs, the headphone will be muted and the LED will
change to RED, searching for another channel will be run automatically.
4. When the batteries of Headphone are at low level, the LED
will blinks in RED. There will be
beeping sound from the headphone in every minute to indicate the last 5 minutes of working,. A
beep sound in each of the first 4 minutes, and 2 beep sound in the last minutes and then it will
automatically switch off.
5. To charge the Batteries in the Headphone, turn OFF the Headphone by pressing the Power button
for about 2 seconds. Place the Headphone on the Transmitter. The charging process begins
automatically, and the CHARGE LED on the transmitter will light in GREEN when the charging
contacts of transmitter and headphone are matched successfully. When the charging process is
completed, the GREEN LED will be OFF.
Note : For the initial use, please charge the batteries for 7 hours. If the headphone is not
in use, please place it back on the transmitter.