User's Manual

Introduction
Thedosimetryradioisusedasawirelesscommunicationdeviceforconnectiontodosimeters.The
dosimetryradioimplementsacustomradiointerfacespecificfordosimetercommunication.
ForcommunicationwithhostthedosimetryradiousesastandardUSBconnection.Thedeviceis
designedasastandardHIDandnodriversareneeded
ifusedwithastandardcomputerand
operatingsystem.
Installation
NodriversareneededandthedosimetryradiocanbeusedonWindows/Linuxcomputersaswellas
customcommunicationdevicesthatareintendedtocommunicatewithdosimeters.
Followtheinstructionsbelowtoinstallthedosimetryradio:
1. ConnectthedosimetryradiotoanyfreeUSBhostportoncomputer/communication

device.
Theradioisnowdetectedbyanysoftwaredes ignedforcommunicationwithdosimeters.
Ifthedosimetryradioisinstalledinacustomcommunicationdeviceandnotastandardcomputer
pleasemakesurethatthedeviceisinpoweroffstatebeforeradioisconnected.
Configuration
Noconfigurationispossibleonthedosimetryradio.
