User manual
User Manual of IR Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
32
Hour and the M refers to Minute.
WEEK WHOLE WEEK
START(H-M) 00 00
END(H-M) 00 00
DONE: OPEN
QUIT: CLOSE
Figure 3-18 Set the Task Time
6. Delete the task.
Move the cursor to TASK CLEAR, click IRIS+ to delete the time and action of the current task,
and click IRIS+ again to confirm the settings and exit.
3.4.6 Configuring Zone
Purpose:
A zone is a panning and tilting area defined by the left/right and up/down limit stops. You can
configure the zones on ZONES submenu. You can define a zone when the targeted surveillance
scene is limited.
Steps:
1. Move the cursor to enter the zone configuration submenu:
MAIN MENU > DOME SETTINGS > ZONES
ZONES
ZONE NUM 1
[UNDEFINED ]
EDIT ZONE
ZONE STATUS ON
SCAN STATUS ON
CLEAR ZONE
BACK EXIT
Figure 3-19 Zone Configuration
2. Choose the zone number:
(1) Move the cursor to ZONE NUM and click IRIS+ button to enter the edit mode.
(2) Click the up and down buttons to select the zone number to be configured.
(3) Click IRIS+ again to confirm the settings and exit edit mode of this column.
Note: Up to 8 zones can be configured.
3. Configure the zone area.
/R&DOO
ZZZFFWYLUHODQGLH
VKRS#FFWYLUHODQGLH