User manual
User Manual of IR Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
18
surveillance environments, which can be set as ON (normally on), OFF (normally off) or TEM
(change according to the temperature).
IR correction settings
This parameter is to correct the focus problems caused by the IR light. You can turn IR CORRECTION
ON or OFF.
Note: IR correction settings vary according to the different camera models.
Fan Parameter Configuration
You can set the FAN CONTROL as TEMP (controlled by the temperature), ON or OFF.
EIS (Electronic Image Stabilization) Configuration
You can set the EIS FUNCTION as ON or OFF; and set the EIS LEVEL as 0-3.
Note: The selectable EIS level varies according to the different camera models.
Preset Direct Focus
You can set the preset direct focus function ON/OF on PRESET DFOCUS submenu.
Protocol and RS-485 settings
Select the protocol.
Choose the protocol on PROTO SET submenu. You can configure it as AUTO MATCH, PELCO-P,
PELCO-D, HIKVISION, KALATEL or VICON. When you choose AUTO MATCH, it is protocol
self-adaptive.
Set the protocol status.
Set the PROTOCOL STATUS SET as ON to enable the user-defined protocol.
Enable the RS-485 configuration diagnosis.
You can set 485CHECK SET as ON or AUTO for automatic RS-485 configuration diagnosis. If the
configuration is incorrect, an alert will be received; if you set the value as AUTO, it will
automatically stop the diagnosis when no errors exist.
Power Memory Settings
The dome can resume its previous PTZ status or actions after it restarted from a power-off. You can
set the power memory to 10S, 30S, 60S, 180S, and 300S.
3.3 Configuring Image Parameters
3.3.1 Configuring Camera Parameters
Purpose:
You can set the camera parameters including focus, shutter speed, iris, etc.
Enter the camera parameters settings menu:
/R&DOO
ZZZFFWYLUHODQGLH
VKRS#FFWYLUHODQGLH