User manual
User Manual of IR Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
16
Display Settings
Purpose:
You can enable or disable the on-screen display of PTZ movements, alarms, time, presets, zone,
address, error rate, and fan/heat show, etc.
Steps:
(1) Move the cursor to DISPLAY SETTINGS using the direction buttons and click IRIS+ to enter.
(2) Move the cursor to the target item and click IRIS+ and click up/down direction buttons to
choose each display mode as ON or OFF, and define each display time as 2 seconds, 5 seconds
or 10 seconds.
(3) Click IRIS+ button to confirm the settings.
Note: If you enable the OSD for both ZOOM and PT, while calling a preset, the preset No. will be
displayed on the screen till the preset scene passes.
DISPLAY SETTINGS
ZOOM SHOW 2
PT SHOW 2
TIME SHOW ON
PRESET SHOW ON
ZONE SHOW ON
ADDRESS SHOW ON
ERROR RATE SHOW ON
BACK EXIT
DISPLAY SETTINGS
FAN AND HEAT SHOW OFF
BACK EXIT
Figure 3-6 Display Settings
The speed dome shows the viewing direction when you manually control it to rotate.
Table 1-2 Viewing Direction Display
Display
N
NE
E
SE
S
SW
W
NW
Indication
North
Northeast
East
Southeast
South
Southwest
West
Northwest
Note: The north direction refers to the zero angle (initial position).
IR Parameter Configuration
Purpose:
You can configure the IR parameters including the IR sensitivity, n/m LED current, reference height,
reference zoom, and LED control, fan control, switch delay, heat control, and IR correction, etc.
Enter the LED parameter submenu:
MAIN MENU > DOME SETTINGS > SYS INFO SETTINGS > IR PARAMETER
/R&DOO
ZZZFFWYLUHODQGLH
VKRS#FFWYLUHODQGLH