User manual
User Manual of IR Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
15
After you enable/disable the soft address, the speed dome will reboot automatically to
activate the settings.
To Set the Broadcast Address of the Speed Dome
When the BROADCAST ADDRESS is set to ON, the control device with address 0 is capable of
controlling all domes connected to it.
Soft Baud Rate Settings
If the SOFT BAUD ACTIVE is set as ON, the soft baud rate is the valid baud rate for the speed dome,
with 2400, 4800, 9600 and 19200 selectable.
If the SOFT BAUD ACTIVE is set as OFF, the baud rate should be set by the DIP switch.
Note: After you enable/disable the soft baud rate, the speed dome will reboot automatically to
activate the settings.
PELCO Checksum
The PELCO CHECKSUM is used for Pelco-P and Pelco-D protocols. If the video turns to slack or
uncontrollable, you can set the PELCO CHECKSUM as ON to improve the video quality.
System Time Configuration
Steps:
(1) Move the cursor to SYS TIME using the direction buttons and click IRIS+ to enter.
(2) Click the left/right direction buttons to position the cursor on the specific item
(year/month/day or hour/minute/second) of which you want to change the value.
(3) Click the up/down direction buttons to increase/decrease the value.
(4) Click IRIS+ button to confirm the settings and exit.
Y - M - D 12 12 12
H - M - S 15 33 25
DONE: OPEN
QUIT: CLOSE
Figure 3-5 Set the System Time
Zero Angle (Initial Position) Configuration
Purpose:
You can define the initial position of the speed dome on the ZERO ANGLE submenu.
Steps:
(1) Move the cursor to ZERO ANGLE using the direction buttons and click IRIS+ to enter.
(2) Click the left/right/up/down direction buttons to adjust the monitor angle of the speed dome.
(3) Click IRIS+ button to confirm the settings and exit.
/R&DOO
ZZZFFWYLUHODQGLH
VKRS#FFWYLUHODQGLH