User guide

Live Viewing Menu
4-10 Configuration and User Guide
2 Choose Select Pattern from the Patterns menu. Figure 4-8 the Select Pattern section will be
displayed.
Figure 4-13 Select Pattern
3 Select the pre-defined pattern from the drop-down menu.
Note
Apple Peel is a predefined pattern stored on the camera by default. This pattern slowly tilts and
rotates the camera through 360 degrees starting at the ceiling line. When the IP Dome reaches
the lowest tilt point it will perform three revolutions. The IP Dome will then follow the tilt and
rotate pattern to return to the starting point. The pattern will run continuously until interrupted by
a camera command, preset, scan or alarm.
4 Select the Start button to activate the pattern. The Live Web Video pane will update to display
the selected pattern.
The pattern will run continuously until interrupted by a camera command, preset, scan or alarm.
Using Pattern as Home Position
The home position runs after a designated period of dome inactivity. Select a home position if you
want to keep a specific area under surveillance whenever the dome is not moving.
Follow Procedure 5-6 Display Current Home Position to change the return time for the home
position.
Procedure 4-22 Using a Pattern as a Home Position
1 Select Patterns from the Live Viewing menu.
2 Choose Select Pattern from the Patterns menu. Figure 4-8 the Select Pattern section will be
displayed.
3 Select a pre-defined pattern from the drop-down menu.
4 Select the Use as Home button to set the selected pattern as the camera home position.
Procedure 4-23 Delete a Pattern
1 Select Patterns from the Live Viewing menu.