User guide

8-2 Configuration and User Guide
4 When the process is complete.
The camera will begin its initial boot up sequence which will take approximately 1 to 2 minutes.
5 Follow Procedure 3-4 Logging in to the IP Dome to confirm that the camera has been returned
to the factory default settings.
Procedure 8-62 Retry Main System Boot
This procedure will maintain all current camera settings including the IP address and all user
accounts and passwords.
1 On the Camera Recovery screen in the Retry Main System Boot section select the Reboot
button.
2 You will be prompted to confirm the reboot.Select the OK button to confirm or the Cancel
button to stop the reboot.
3 If OK was selected the Camera Rebooting Progress bar will appear and the IP Dome will
reboot.
4 When the process is complete.
The camera will begin its initial boot up sequence which will take approximately 1 to 2 minutes.
5 Follow Procedure 3-4 Logging in to the IP Dome.
Note
If Figure 8-35 Camera Recovery screen appears the reboot has been unsuccessful and this
procedure may have to be repeated. Alternatively follow Procedure 8-61 Using Camera
Recovery to restore the firmware on the IP Dome.