Instruction manual

SmartWatch® IP PTZ Dome Cameras - Manual
68
1. Enter the Record Schedule Settings interface:
Configuration > Advanced Configuration> Storage > Record Schedule
Recording Schedule Interface
2. Check the checkbox Enable Record Schedule to enable scheduled recording.
3. Set the record parameters of the speed dome.
Record Parameters
 Pre-record: The time you set to start recording before the scheduled time or
the event. For example, if an alarm triggers recording at 10:00, and the pre-
record time is set as 5 seconds, the speed dome starts to record at 9:59:55.
The Pre-record times can be configured as 5 s, 10 s, 15 s, 20 s, 25 s, 30 s or not
limited.
The pre-record time changes according to the video bitrate.
 Post-record: The time you set to stop recording after the scheduled time or
the event. For example, if an alarm triggered recording ends at 11:00, and the
post-record time is set as 5 seconds, the speed dome records until 11:00:05.
The Post-record time can be configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min
or 10 min.
 Overwrite: If enabled when the HDD is full, it overwrites the oldest record files
automatically.
The Pre-record and Post-record parameters vary depending on the speed dome
model.
4. Click to edit the record schedule.